2015 CHEVROLET CORVETTE C7 Z06 MANUAL COUPE
Import approval dated 6th of June 2017, suggests this vehicle was imported into Australia sometime after that date.
We hold a data card with all the features of the car as it left the USA.
The following information has been supplied by the current owner, as to modifications made and it suggests this vehicle is most suited to tarmac rally and competition use, however it has been registered for the road in Tasmania as a “Special Interest Vehicle”.
Please be aware, “Special Interest Vehicle” status does not apply in all jurisdictions.
2015 Corvette C7 Z06 Works to date
Engine
Green air filter
Smaller S/C pully
New drive belt
2017 S/C cover
Fuel sampler
Oil & Cooling system
Dewitt 3 part upgrade
Remote twin oil coolers in brake ducts
Braided lines from oil scavenge point to new coolers
Modified rad support to increase flow through radiator
Remove seal on back of bonnet and open to allow heat to escape from engine bay
Clutch
Factory clutch replaced with extreme ceramic twin plate with lightened fly wheel
Remote bleeder heat shielded to the engine bay
Exhaust
Custom stainless headers by Pacemaker Header with delete cat, ceramic coated
Titanium mid section with cross flow, ceramic coated
3 inch tail section with Bi modal delete and remote mount Bi motors for cambus
Brakes
Upgrade to Z07 performance package including full carbon rotors and pads reducing weight and increased braking power
Suspension
MCA latest Olins copy with remote canisters, (A C7 was loaned for a week to allow completion of the design and calculations
LG Motorsport simulators to bypass Magride suspension
LG Motorsport Monoball control arm kit
LG Motorsport rear HD tie rods
LG Motorsport solid diff mount
Smaller Stingray rear sway bar
Gearshift
Factory no lift shift and launch mode
MGW C7 quick shift
Cabin
Door skins replaced, minor carpet removed with weight reduction achieved but still more able to be removed
Seats are Velo Apex winged STD 2018
AMT Alloy ultra low motorsport seat mounts
Full service book of all works and changes to car
Powered by a 6.2 Litre supercharged LT4 V8 engine. in ex factory form it was claimed to produce 485Kw and 881Nm of power and torque and delivered through a 7 speed manual gearbox to the rear wheels. With the modifications mentioned above, it is likely to be a very quick car!
Available to admire on our showroom floor in Adelaide.
We can arrange transport door to door Australia wide.
We welcome the opportunity to consider your trade in.
Make: | Chevrolet |
Model: | Corvette C7 Z06 |
Built: | 2015 |
KM: | 23960 |
Engine Size: | 6200 |
Cylinders: | 8 |
Transmission: | Manual |
Price: | Sold |